Fun Facts About Crystals

Tech Specs

Code Zubi Flyer

Fuze Install Kit

Zubi Flyer Pin Assignments

In The Box 

• Zubi Flyer Frisbee
• Illuminator Printed Circuit Board 
• Magnet Wand
• Instructable Booklet
• Happy Face Micro-USB
• Diffraction Glasses (2 Pairs) 
• Battery 
• Accessory Box

Built-In Features

• 12 Fun Games
  Newbie Zubie, Catch the Light, Hot Potato, Copy Cat, Hand Harmonica, Telephone, Pong, RGB Light Hack, RGB Single Light Hack, Shortcut Hack, Mood Light, Name that Tune
• Connect Online
  Connect Zubi to a computer to learn coding
• Tactile Building
  Physically assemble the flyer
• Educational Instructable - Learn how Zubi works, or explore fun facts about electrical current flow and different forms of energy
• Creatively Explore Light
  See light differently with our fun light diffraction glasses, and play with over 16 million hues of color
• Digitally Explore Sound
  Control 7 octaves of sound with the buzzer
• Electronics Exploration
  Reed & Button Switches, 7 Octave Piezo Buzzer, Circuits & Circuit Board, Microcontroller, Push Buttons, RGB LEDs, Electrical Current Flow, Forms of Energy
• Arduino - Open Source
  Our programs are FREE for anyone to use with access to FREE code repositories where you can explore the endless possibilities of coding your Zubi Flyer 
• Online Learning Portal
  Our FUZE website will have a FREE learning portal that will have a minimum of three courses that will walk you through the process of changing code on your flyer

Electronics Parts

• PC Board
• IC MCU 8BIT 32KB FLASH 44QFN (ATMEGA32U4)
• AUDIO PIEZO TRANSDUCER 30V TH
• 5050 APA102C THREE-COLOR LED SMD
• PHOTOCELL 27-60KOHM
• SWITCH REED SPST-NO 500MA 140V
• TACTILE SWITCH SPST-NO 0.02A 15V
• SWITCH PUSHBUTTON SPST 2A 14V

Microcontroller Specs 

The Zubi Flyer is the bomb dot com for makers: 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Running at 16MHz and 5V. The onboard switch-mode boost regulator is designed to operate on 3 Volts.  Power can be supplied from a 3 Volt CR123A battery or from a USB cable that provides regulated +5 Volts DC to the board. Do not run any power exceeding 5 Volts as the regulator cannot handle step-down voltage.

• ATmega32U4 running at 5V/16MHz
• Supported under Arduino IDE v1.0.1
• On-Board micro-USB connector for programming
• Rx and Tx Hardware Serial Connections

System Requirements

• Real Code
  Learn C
• Downloads 
  Zubi Flyer .ZIP Library
  Zubi Flyer Drivers (Windows only)
• Supported OS
  Mac + Windows
• PIN Assignments 
  See PIN Assignments HERE