Zubi Flyer Pin Assignments

If you are on this page you most likely are well aware that in electronics a PIN or (sometimes "pin-out") is a contact point for an electronic component and its related functions.  Here you will find the PIN assignments for the Zubi Flyer.  

We are very supportive of the open-source and general Maker Community.  Please reach out with anything you feel deserving to share.  And, if you are so inclined to share with us your project we would greatly appreciate it! 

Try sharing your project through Hackster.io, or just email us: zubi@fuzeplay.io

Zubi Flyer Arduino PIN Assignments

 

Tech Specs

Code Zubi Flyer With Arduino 

Click HERE for the Fuze Install Kit

Code Zubi Flyer With ScratchX 

Click HERE to beta the Fuze ScratchX Extension

In The Box 

Built-In Features

Electronics Parts

Microcontroller Specs 

The Zubi Flyer is the bomb dot com for makers: 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Running at 16MHz and 5V. The onboard switch-mode boost regulator is designed to operate on 3 Volts.  Power can be supplied from a 3 Volt CR123A battery or from a USB cable that provides regulated +5 Volts DC to the board. Do not run any power exceeding 5 Volts as the regulator cannot handle step-down voltage.

System Requirements

learn how stuff works!

stars in space on way to mars