Getting Started with Zubi Flyer ScratchX

fuze play scratch extension
zubi flyer scratch extension


WHAT YOU WILL DO

In this project you will FUZE the physical world of the Zubi Flyer with the virtual world of ScratchX using a special extension that allows the Zubi Flyer to talk to ScratchX and vice versa. 

You will learn how to create your sprite in ScratchX and then drag and drop blocks allowing your Zubi Flyer to be used to control your virtual world.  

 

 

WHAT YOU WILL LEARNarduino-scratch-ready

By following this project guide you will learn: How to use the Arduino programming environment to allow your Zubi Flyer to communicate with ScratchX

  • How to setup the Zubi Flyer with ScratchX online
  • Experimenting with placing different types of blocks with special attributes
  • How to use Zubi Flyer ScratchX to build virtual world and control it using your Zubi Flyer

 

GET STARTED

Tech Specs

Code Zubi Flyer With Arduino 

Click HERE for the Fuze Install Kit

Code Zubi Flyer With ScratchX 

Click HERE to beta the Fuze ScratchX Extension

In The Box 

Built-In Features

Electronics Parts

Microcontroller Specs 

The Zubi Flyer is the bomb dot com for makers: 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Running at 16MHz and 5V. The onboard switch-mode boost regulator is designed to operate on 3 Volts.  Power can be supplied from a 3 Volt CR123A battery or from a USB cable that provides regulated +5 Volts DC to the board. Do not run any power exceeding 5 Volts as the regulator cannot handle step-down voltage.

System Requirements

learn how stuff works!

stars in space on way to mars